Current: charge in motion
Charge sitting still does nothing useful. Light, sound, motion and computing all come from charge on the move, and the name for moving charge is current.
Current isn't how much charge there is, or how fast each electron goes. It's how much charge passes a point each second, in the same way that the flow of a river is litres per second past a bridge.
Here is a wire with a gate across it that counts the charge going past. Change the flow and watch the three numbers.
The maths
| Symbol | Meaning | Unit |
|---|---|---|
| current | amps (A) | |
| charge that passed | coulombs (C) | |
| the time it took | seconds (s) |
Worked example. 12 C of charge pass through a lamp in 4 s. The current is
(Current is written , from the French intensité, because was already taken by the coulomb.)
18 C of charge passes through a motor in 4 s. What is the current?
Answer in A.
Turned round, the same formula gives the charge: .
An LED carries 20 mA for 20 seconds. How much charge has passed through it?
Answer in C.
Which way does it go?
You saw two arrows in the figure. The electrons really drift from the battery's − around to its +. But circuits were being drawn for a century before electrons were discovered, and by then everyone had agreed to draw current flowing from + to −.
That agreement stuck. It's called conventional current, and it is what every arrow on every circuit diagram, every formula and every lesson here uses. It works perfectly: negative charge going one way has exactly the same effect as positive charge going the other.
In a simple loop of a battery, a resistor and an LED, which way does conventional current flow?
- Out of the battery's +, through the parts, back to its −
- Out of the battery's −, through the parts, back to its +
- Out of both ends of the battery, meeting in the middle
Going deeper
- Electrons are slow; electricity is fast. In a wire carrying an ordinary current the electrons drift at well under a millimetre a second. Yet a light comes on the instant you close a switch, because the wire is already full of electrons: push one in at one end and one pops out of the other at once, like a pipe already full of water.
- Current is the same all the way around a single loop. The gate could be anywhere along the wire and count the same. Charge isn't used up by a lamp or an LED; it only gives up energy there. That is the subject of the next lesson.
| Typical currents | |
|---|---|
| A wristwatch | a few µA |
| An indicator LED | 2 to 20 mA |
| A phone charging | 1 to 3 A |
| A kettle | about 10 A |
| A car's starter motor | 200 A or more |
On a real bench most of what you build on a breadboard runs on milliamps. A breadboard's clips and jumper wires are good for about 1 A at most; more than that needs thicker wire and soldered joints.