Sensor dividers: the thermistor
A thermistor is a resistor made to change with temperature. This one is an NTC thermistor, for negative temperature coefficient: its resistance goes down as it warms up. It's rated 10 kΩ, which is its resistance at 25 °C.
An ohmmeter is across it. Press Run, open the multimeter to see its reading, then click the thermistor and set its temperature to each of the values in the table. What does it read at 0 °C?
Answer in Ω.
Put the thermistor at the bottom of a voltage divider, and its falling resistance makes the output fall as it warms.
But the fixed resistor above it has to be chosen. Suppose the job is to measure temperatures from 0 °C to 50 °C. The more the output moves across that range, the easier the reading is to measure precisely, so the aim is the biggest swing in output.
Try fixed resistors here and find the one that gives the biggest swing.
Why the middle?
With a fixed resistor much smaller than the thermistor, the thermistor takes almost all the voltage at every temperature, so the output sits near 9 V and barely moves. With one much bigger, the output sits near 0 V and barely moves. In between, the two share the voltage and the share changes a lot.
The swing is largest when the fixed resistor is about the geometric mean of the sensor's two extremes:
So 10 kΩ, the thermistor's own rating, is a good choice for this range.
The same thermistor is to measure a hot range instead, 50 °C to 80 °C, where it goes from 3.6 kΩ to 1.2 kΩ. About what fixed resistor gives the biggest swing there?
Answer in Ω.
Build it. Across the 9 V battery, make a divider from a thermistor and a fixed resistor of your choice, wired either way up, whose output swings as far as possible between 0 °C and 50 °C.
To pass, the output must be above 6 V at one end of the range and below 3 V at the other.
At 25 °C your divider's output is half the supply. Is the output at 37.5 °C, halfway up the range, also halfway between the outputs at 25 °C and 50 °C?
- Close, but not exactly: the output isn't a straight line against temperature
- Yes, exactly
- No, it's nowhere near
A thermistor divider:
- an NTC thermistor's resistance falls as it warms, steeply and not in a straight line;
- in a divider, its output follows temperature;
- for the biggest swing over a range, choose the fixed resistor near : the middle of the sensor's range;
- the same rule works for any resistive sensor: an LDR, a strain gauge, a gas sensor.
On a real bench the divider's current warms the thermistor itself a little, so it reads high. Keeping the current small, with resistors of 10 kΩ or more, keeps that error down.