Voltage is always between two points
A voltage is a difference between two points. That's why a multimeter has two probes: it tells you how much higher the red probe is than the black one.
On the board, two resistors sit in a row across a 9 V battery. Press Run to switch it on.
The colours show each part of the circuit's voltage, from blue (low) to red (high).
Open the multimeter with the meter button at the bottom left of the board. Leave it on Volts. Put the red probe in the column between the two resistors, and the black probe on the black − rail.
What does it read?
Answer in V.
Now leave the red probe where it is, and move the black probe to the red + rail.
Same point, same circuit. What does the meter read now? Type it exactly as shown.
Answer in V.
What does a negative reading on a voltmeter mean?
- The meter is broken, or the circuit is
- The red probe is on a point lower in voltage than the black probe
- Current is flowing backwards through the resistors
One more. Put the red probe on the + rail and the black probe on the − rail, to measure across everything.
Answer in V.
Ground: an agreed zero
So is the middle point at 6 V, or at -3 V? Both, depending on where you measure from. Saying "this point is at 6 V" only means something once everybody agrees on the second point.
That agreed point is called ground (or 0 V, or GND). It's a choice, and almost always the choice is the battery's − side. From then on, the "voltage at" any point means the voltage between it and ground.
Suppose we chose differently, and called the middle point ground. What would the voltage at the − rail be then?
Answer in V.
What you've found:
- A voltage is always between two points. One probe on its own measures nothing.
- A voltmeter reads red minus black, so the sign tells you which point is higher.
- Ground is the point we agree to call 0 V, usually the battery's −. "The voltage at a point" is measured from there.
- Voltages along a path add up.
On a real bench a multimeter's black lead plugs into the socket marked COM (common), and you'd usually clip it to ground and leave it there, moving only the red probe from point to point.