Kirchhoff's voltage law

Lab · 9 min

In the last lesson, the voltages across two resistors in series added up to exactly the battery's voltage. That was no accident. It is a law, and it holds for every loop in every circuit.

Here are three resistors in series: 1 kΩ, 2.2 kΩ and 3.3 kΩ, across a 9 V battery. Press Run.

The colours show the voltage falling in three steps on the way from + to −. Each step is the voltage drop across one resistor.

Press Record a reading to note all three drops and the battery's voltage.

Then change the battery's voltage and record again. Do it for at least three different battery voltages.

Pick any row of your table and add up its three drops. What do they come to?

  • Less than the battery's voltage: some is lost on the way
  • Exactly the battery's voltage
  • More than the battery's voltage

Kirchhoff's voltage law

Around any closed loop, the voltage rises add up to the voltage drops.

For this loop:

Vbattery=V1+V2+V3

Think of a walk in the hills that ends where it began. However the path wanders, the total climbed equals the total descended, because you finish at the height you started from. Voltage is the electrical version of height, so the same must be true of any trip around a circuit that comes back to its starting point.

It's named after Gustav Kirchhoff, who wrote it down in 1845 while still a student, and it's usually shortened to KVL.

What if the 3.3 kΩ resistor were swapped for a 1 kΩ? The current would change, and so would each drop. What would the three drops add up to then?

  • Less than before: there's less resistance to drop it across
  • The same as before: the battery's voltage
  • More than before: more current flows

Try it. Click the third resistor (the one nearest the − rail) and change its value to 1 kΩ. Then press Record a reading.

KVL lets you find a voltage you haven't measured.

A loop has a 12 V battery and three parts in series. Two of them have 1.5 V and 2 V across them. What is the voltage across the third?

Answer in V.

You have already used KVL without knowing its name. A red LED with about 2 V across it is in series with a resistor on a 9 V supply. What is the voltage across the resistor?

Answer in V.

What you've found:

  • Around any loop, the drops add up to the rises. In a single loop: the parts' voltages add up to the battery's.
  • It holds whatever the battery's voltage and whatever the parts are.
  • If you know all the voltages in a loop but one, KVL gives you the last.

Going deeper

KVL is the conservation of energy in disguise. A volt is a joule per coulomb, so the battery's voltage is the energy it gives each coulomb, and each drop is the energy that coulomb hands over to a part. A coulomb that arrived back at the battery with energy left over, or in debt, would break the conservation of energy.

On a real bench the sum can come out a few hundredths of a volt short. The missing bit is across the wires, the breadboard's contacts and the battery's own insides, which are all small resistors in the same loop.