Maximum power transfer

Lab · 12 min

The sealed box is back: inside, a 9 V battery and three resistors; outside, the same as 6.19 V behind 1.16 kΩ. Its output now has a load across it.

Which load takes the most power from the box? A tiny load takes a big current but has almost no voltage across it. A huge load has nearly all of Vth across it but takes almost no current. Somewhere between, the product V×I is biggest.

Where do you think the peak is?

  • With the smallest load: most current
  • With a load equal to the box's own 1.16 kΩ
  • With the biggest load: most voltage

Find out. Press Run, then Record a reading: the table notes the load's voltage and current, and the graph works out its resistance and power.

Then click the load, pick another value, and record again. Cover the range from 220 Ω to 4.7 kΩ, at least six different loads.

Which load took the most power? Give its resistance.

Answer in Ω.

Maximum power transfer

A source delivers the most power to a load whose resistance equals the source's own Rth.

With RL=Rth the load gets half of Vth, and the current is Vth/2Rth, so the most power available is

Pmax=Vth24Rth

For the box: 6.19² ÷ (4 × 1157.5) = 8.3 mW.

But look at where the rest goes. At the peak, the same current flows through Rth inside the source, with the same voltage across it as the load has. So the source wastes exactly as much as it delivers.

At maximum power transfer, what fraction of the power drawn from Vth reaches the load?

  • Half
  • All of it
  • A quarter

So when do you want a matched load, and when not?

  • Match when the signal is weak and every bit of it counts (an aerial, a microphone); don't when it's a power supply, where wasting half would be absurd
  • Always match: maximum power is always best
  • Never match: 50% efficiency is always bad

Maximum power transfer:

  • a source delivers the most power into a load equal to its own Rth: Pmax=Vth2/4Rth;
  • at that point the efficiency is only 50%: as much is lost inside the source as reaches the load;
  • match loads for weak signals; for power, keep the load much bigger than the source's resistance.