Norton equivalent

Calculate · 9 min

A Thévenin equivalent is a battery behind a series resistor. Two lessons ago you saw that a battery with a series resistor can be swapped for a current source with a parallel resistor, and nothing outside can tell.

So every network also has a Norton equivalent: a current source IN in parallel with a resistor RN.

  • RN is the same as Rth: the resistance at the terminals with the sources turned off.
  • IN: join the terminals with a wire and find the current in that wire, the short-circuit current.

Shorting the terminals of a Thévenin source puts its whole Vth across Rth, so IN=Vth/Rth. And opening the terminals of a Norton source sends all of IN through RN, so Vth=IN×RN. Three numbers, any two of which give the third.

The sealed box from earlier was 6.19 V behind 1,157.5 Ω. What is its Norton current?

Answer in mA.

Network 1. Join A to B with a wire. What current flows in that wire? That is IN.

Answer in mA.

Network 1, checked. The same network's Thévenin equivalent is Vth=V×R2/(R1+R2) behind Rth=R3+R1∥R2.

Work out Vth/Rth for these values. Does it match your short-circuit current?

Answer in mA.

Network 2. Norton is handiest when sources are in parallel, because current sources in parallel simply add.

Treat R2 as the load. Seen from R2's ends, each battery with its series resistor is a Norton source: V1/R1 in parallel with R1, and V2/R3 in parallel with R3. Add the currents, combine the resistors, and you have one Norton source feeding R2.

What is the voltage across R2?

Answer in V.

Network 3. A sensor behaves like a Norton source: 100 µA in parallel with 10 kΩ. What is its Thévenin equivalent's voltage?

Answer in V.

Thévenin or Norton: when is each the more natural model?

  • Thévenin when R_th is small, so the output is nearly a fixed voltage; Norton when R_N is large, so it's nearly a fixed current
  • Thévenin for batteries, Norton for everything else
  • Norton is only for circuits with current sources in them

The Norton equivalent:

  • a current source IN in parallel with RN;
  • IN is the short-circuit current; RN=Rth;
  • IN=Vth/Rth and Vth=INRN: Thévenin and Norton are the same thing written two ways;
  • sources in parallel are easiest in Norton form, since their currents add.