Nodal analysis I
This circuit has one unknown node voltage, , and no series or parallel shortcut to find it. Nodal analysis finds it with Kirchhoff's current law.
The current in any resistor is the voltage across it over its resistance, and the voltage across it is the difference of the node voltages at its ends. So the current flowing into N through R1 is . Write the same for every resistor at N, and KCL says they add up to zero:
Don't worry about which way each current really flows. Write every one as flowing in. A current that really flows out just comes out negative, and the sum still balances.
Worked example, with V1 = 9 V, V2 = 6 V, R1 = R3 = 1 kΩ and R2 = 2.2 kΩ. Multiply through by 1 kΩ:
Which way does current flow in R3 in this example?
- From N to V2: N is at 6.11 V and V2's end at 6 V
- From V2 to N: V2 is a battery, so it pushes current out
- No current flows in R3
Problem 1. Find the node voltage .
Answer in V.
Problem 2. One battery, and a load on the right. Nodal analysis doesn't mind: R3 and the load carry the same current, so from N they act as one resistor to ground.
Find .
Answer in V.
Problem 3. The second battery is now bigger than the first. Find .
Answer in V.
Now check the method against a real circuit. The board holds the worked example: a 9 V battery on the rails, R1 = 1 kΩ, R2 = 2.2 kΩ to the − rail, and R3 = 1 kΩ to a 6 V battery whose − lead shares the − rail.
You worked out = 6.11 V for it. Measure it: the multimeter's red probe on the node (column 8, where the three resistors meet), black on the − rail. What does it read?
Answer in V.
Nodal analysis, one unknown node:
- choose ground and name the unknown node;
- for each resistor at the node, write the current in through it: ;
- set the sum to zero (KCL) and solve for ;
- any current or voltage in the circuit follows from the node voltages.
On a real bench circuit simulators, including the one running this lesson, do exactly this: they write KCL at every node and solve all the equations at once.