Node voltages

Quiz · 7 min

Series and parallel rules can't work out every circuit. This one has two batteries, and no two of its resistors are in series or in parallel. The next few lessons give you methods that work on any circuit, and they all start by naming its nodes.

A node is a set of points joined by nothing but wire. However long or bent the wire, everywhere along it is at one voltage. A node ends where a part begins.

How many nodes does this circuit have?

  • 3
  • 4
  • 5
  • 7

Ground

A voltage is always between two points. To give each node one number, pick one node as the reference, call it 0 V, and measure every other node from it. The reference is called ground, and drawn with this symbol: ⏚.

Any node will do, but one choice makes the maths easiest. For the circuit above, which node is the best choice?

  • The bottom wire: it touches both batteries' − ends and R2
  • The middle junction, where three resistors meet
  • The top-left wire

Node voltages

Once every node has a voltage, the voltage across any part is the difference between the nodes at its two ends:

Vpart=Vone end−Vother end

In this circuit, ground is the bottom wire, so the top-left node is at 12 V and the top-right node at 3 V. The middle node, N, measures 7 V.

What is the voltage across R1?

Answer in V.

A ladder: one battery, with resistors along the top and rungs down to the bottom. With ground at the bottom, how many nodes have a voltage you don't yet know?

  • 1
  • 2
  • 3
  • 4

In that ladder the two junctions measure 5.5 V and 1.5 V. What is the voltage across R3, the resistor between them?

Answer in V.

The same ladder with a second battery feeding the far end through R5. With ground at the bottom, how many node voltages are unknown now?

  • 1
  • 2
  • 3
  • 4

Last one. Here the right-hand battery has been replaced by a plain wire. How many nodes does the circuit have now?

  • 2
  • 3
  • 4

Nodes and node voltages:

  • a node is everything joined by plain wire: one voltage, however it's drawn;
  • choose one node as ground, 0 V, usually the one touching the batteries' − ends;
  • each other node then has one voltage, measured from ground: the black probe on ground, the red on the node;
  • any part's voltage is the difference of the node voltages at its ends.

Next: a method that finds the unknown node voltages from the resistor values.