Non-ohmic parts

Lab · 10 min

Ohm's law says a resistor's current is proportional to its voltage: plot one against the other and you get a straight line through zero. A part like that is called ohmic.

Many parts aren't. The quickest way to get to know any two-legged part is to draw this graph for it, its I–V curve: how much current flows at each voltage.

First, a resistor again, for comparison. Press Run.

Record a reading at four or more battery voltages between 1 V and 9 V.

Now an LED. It has a 330 Ω resistor in series to keep it safe, but the readings you take will be the voltage across the LED alone, and the current through it.

What shape will the LED's graph be?

  • A straight line through zero, like the resistor's
  • Flat at first, then shooting almost straight up
  • A level line: the same current at every voltage

Press Run, then record a reading at six or more battery voltages from 1 V up to 9 V. Take several below 3 V: try 1, 1.5, 2, 3, 6 and 9 V.

Take two of your LED readings: one at a few milliamps and one at 20 mA or so. For each, work out voltage ÷ current, as you would to find a resistance. What do you find?

  • The same number each time, as for a resistor
  • Different numbers: an LED has no single resistance
  • Zero each time

Three shapes

Here are the I–V curves of three parts: a resistor, an LED, and a filament lamp (a torch bulb).

A lamp's filament gets very hot as the current rises, and hot metal resists more than cold metal. So each extra volt buys a little less extra current than the one before.

Match each curve to its part.

Match each of these:

  • Curve A
  • Curve B
  • Curve C

with one of these:

  • LED
  • Resistor
  • Filament lamp

What you've found:

  • An I–V curve shows how a part behaves at every voltage.
  • A straight line through zero means ohmic: Ohm's law holds, with one fixed resistance.
  • An LED is non-ohmic: off below its forward voltage, then a steep wall.
  • A filament lamp is non-ohmic too, because heat changes its resistance.

On a real bench an instrument called a curve tracer draws these graphs in one sweep. Without one, you do what you did here: a variable supply, a protecting resistor, and a meter each for volts and milliamps. Never sweep an LED's voltage without that resistor in series.

That's the end of this module. Next: what happens when a circuit has more than one resistor.