Power ratings and heat

Predict · 8 min

The power a resistor takes becomes heat, and the resistor has to get rid of it into the air around it. A small part can only shed so much. Ask for more and it gets hotter and hotter until it scorches, changes value, or burns.

So every resistor has a power rating: the most it can dissipate continuously. For the ordinary small resistors in this simulator, and in most kits, that is ¼ W (0.25 W).

On the board, three resistors each sit straight across the 9 V battery:

ResistorValue
Left100 Ω
Middle220 Ω
Right1 kΩ

Each resistor has the full 9 V across it. Work out the power in each with P=V2/R.

Which of them will go over ¼ W? Choose every one that will.

Choose all that apply.

  • The 100 Ω
  • The 220 Ω
  • The 1 kΩ

Press Run and see.

The smallest safe value

Turn P=V2/R round to find the resistance that dissipates exactly a given power:

R=V2P

What is the smallest resistance that can sit across 9 V without going over 0.25 W?

Answer in Ω.

A resistor running at its rating is still very hot: too hot to touch, and hot enough to age quickly. The usual rule is to run a part at no more than half its rating. Leaving that margin is called derating.

Half of ¼ W is 0.125 W, and across 9 V that needs at least 81 ÷ 0.125 = 648 Ω.

Stop the simulation. Then click each overheating resistor and change it to a value that keeps it at or under 0.125 W.

What you've found:

  • Power in a resistor becomes heat. The power rating is the most it can shed.
  • Work out the power before you build: P=V2/R or P=I2R.
  • Aim for half the rating or less.

Going deeper

A rating is given for cool surroundings, usually up to 70 °C. In a hot, closed box a resistor can shed less heat, so its allowed power falls, on a straight line down to zero at about 155 °C. Datasheets show this as a derating curve.

When the sums say you need more than a small resistor can take, use a physically bigger one. They come in ½ W, 1 W, 2 W and up, each larger than the last because the size is what sheds the heat.

On a real bench an overloaded resistor gives you some warning: it smells, then its paint darkens, then it smokes. The simulator can't warn you by smell, and a real one at 0.8 W would burn your finger long before it failed. If something on your board is hot, switch off first and work out why afterwards.