Power

Calculate · 7 min

A resistor holding current back gets warm. An LED gives off light. Both are turning electrical energy into something else, and power is how fast they do it: the energy converted each second.

Power is measured in watts (W). One watt is one joule per second.

The maths

Voltage is joules per coulomb. Current is coulombs per second. Multiply them and the coulombs cancel, leaving joules per second:

P=V×I
SymbolMeaningUnit
Ppowerwatts (W)
Vvoltage across the partvolts (V)
Icurrent through itamps (A)

Worked example. An LED has 2 V across it and carries 20 mA:

P=2 V×0.02 A=0.04 W=40 mW

A small motor runs from 9 V and draws 50 mA. How much power does it use?

Answer in W.

Two more forms

For a resistor, Ohm's law lets you swap out whichever of V and I you don't know.

Put V=IR into P=VI:

P=I2R

Or put I=V/R into it:

P=V2R

All three give the same answer. Use whichever fits what you know.

Notice the squares. Double the current through a resistor and it makes four times the heat.

30 mA flows through a 47 Ω resistor. How much power does the resistor turn into heat?

Answer in mW.

A 100 Ω resistor is connected straight across a 9 V battery. How much power does it dissipate?

Answer in mW.

The battery across a resistor is swapped for one of twice the voltage. What happens to the power the resistor dissipates?

  • It stays the same
  • It doubles
  • It goes up four times
  • It halves

The three forms:

P=VIP=I2RP=V2R

P=VI is true for any part. The other two are for resistors, because they lean on Ohm's law.

Going deeper

In a resistor, all the power becomes heat. That isn't waste in a kettle or a toaster, which are just big resistors. In an LED circuit it is the price of limiting the current: the resistor often throws away more power than the LED uses.

On a real bench every part has a power rating: the most it can turn into heat without overheating. Ordinary small resistors are rated a quarter of a watt. The lesson after next shows what happens when you go past it.