Reading a resistor and battery datasheet

Datasheet · 10 min

Every part comes with a datasheet: the maker's description of what it does and the limits it's guaranteed to stay within. Designing a circuit is mostly looking things up in them.

Here is one for an ordinary carbon film resistor. A few things on it you've met already: the resistance range, the tolerance. Others are new.

What is its rated power, at room temperature?

Answer in W.

A resistor turns its power into heat, and gets rid of it to the air around it. If the air is already hot, it can't get rid of as much, so the safe power falls. That's derating: the curve under the table.

Inside a sealed box next to a hot regulator, the air is at 100 °C. What power can this resistor safely take there?

Answer in mW.

The temperature coefficient says how much the resistance drifts as the part warms up, in parts per million per degree (ppm/°C). 1 ppm is a millionth.

A 10 kΩ resistor from this sheet warms up by 50 °C. By how much can its resistance change, at most?

Answer in Ω.

Now the battery's sheet. A battery's capacity, in milliamp-hours, is how much charge it delivers before its voltage drops to a cut-off below which it's counted as flat.

The graph shows three discharges at constant currents. A circuit draws a steady 100 mA. Roughly how long will this battery run it?

Answer in h.

At 500 mA the same battery gives only about 250 mAh. Where has the rest gone?

  • Its internal resistance drops more voltage at high current, so it reaches the cut-off sooner, with charge still inside
  • It's used up faster, so there's less of it
  • The datasheet is measured at a different temperature

Reading a datasheet:

  • the rated power holds up to a stated temperature, then derates to zero;
  • the temperature coefficient in ppm/°C says how far the value drifts as it warms;
  • a battery's capacity depends on the load: read it from the curve at your current, not the headline figure;
  • hours = capacity (mAh) ÷ current (mA).