Series vs parallel LEDs
Resistors can be joined in series or in parallel, and so can LEDs. The two ways behave very differently, and each is used for good reasons.
First, series: one resistor, then two red LEDs one after the other, on 9 V. Press Run.
Suppose one of the two LEDs is pulled out of the board. What will the other one do?
- Stay lit, as before
- Get brighter: it has the current to itself
- Go out
Try it. Delete one of the LEDs, either one.
Now parallel: each LED has its own resistor and its own path from the + rail to the − rail. Press Run.
Same question. If one of these LEDs is pulled out, what will the other one do?
- Stay lit, as before
- Get brighter: it gets the other one's current too
- Go out
Try it. Delete one of the LEDs.
With both LEDs in place, the two circuits drew different currents from the battery:
| Through each LED | From the battery | |
|---|---|---|
| Series | 15.4 mA | ? |
| Parallel | 21.2 mA | ? |
Which circuit takes more current from the battery?
- Series: the current has to get through two LEDs
- Parallel: the battery supplies each branch separately
- Neither: two LEDs need the same current however they're wired
Series has a cost, though. Here is the series pair again, on a 3 V battery (two AA cells) this time.
Each red LED needs about 1.8 V before it lights at all. Will these two light?
- Yes, a little dimmer than on 9 V
- No, neither will light
Press Run and see.
A strip of white LEDs runs from a 12 V supply. Each white LED needs about 3 V. What is the largest number that can go in one series chain and still leave some voltage for the resistor?
- Two
- Three
- Four
- Six
Your turn. On this board, build two red LEDs so that either one can be taken out without the other going dark. Each should carry between 8 and 28 mA.
The drawer has 330 Ω resistors, red LEDs and wires.
The two ways of wiring LEDs, side by side:
| LEDs in series | LEDs in parallel | |
|---|---|---|
| One LED removed | all go out | the rest stay lit |
| Supply voltage needed | the forward voltages added up, and a bit more | one forward voltage, and a bit more |
| Current from the supply | one LED's worth | one LED's worth per branch |
| Resistors | one for the chain | one for each branch |
Neither is better. Series saves current and parts; parallel works from a low voltage and keeps going when one LED fails. Real products mix the two.
On a real bench LEDs usually fail by going open, like a blown bulb, so a series chain goes dark all at once. That makes the fault easy to notice and tedious to find.