Short circuits and open circuits
Circuits fail in two basic ways. A path that should be there is broken: an open circuit. Or a path that shouldn't be there has appeared: a short circuit. You can find both with a voltmeter and the laws you already know.
This board has three 1 kΩ resistors in series across 9 V. If all were well:
| Should be | |
|---|---|
| Current | 9 V ÷ 3 kΩ = 3 mA |
| Across each resistor | 3 V |
Press Run and watch for the moving dots.
Think before measuring. No current flows, so by Ohm's law each good resistor has = 0 V across it.
But Kirchhoff's voltage law still holds: the voltages around the loop must add up to the battery's 9 V. So what is the voltage across the broken resistor?
- 0 V, like the others
- 3 V, its usual share
- 9 V, the whole supply
Find it. Measure the voltage across each of the three resistors in turn. Which one is open?
- The left one
- The middle one
- The right one
Replace the broken resistor: delete it, and put a new 1 kΩ from the drawer in its place.
A second board, built the same way, with a different fault. Press Run.
A shorted resistor behaves like a plain wire, with almost no resistance. The current through it isn't zero this time. So what voltage do you expect across it?
- About 0 V
- 3 V, its usual share
- 9 V, the whole supply
Measure across each resistor again. Which one is shorted?
- The left one
- The middle one
- The right one
Replace the shorted resistor with a new 1 kΩ from the drawer.
Both faults put 0 V across some parts, so a single reading isn't enough:
| Open circuit | Short circuit | |
|---|---|---|
| Current in the loop | none | more than normal |
| Across the faulty part | the whole supply | 0 V |
| Across the good parts | 0 V | more than normal |
A string of four lamps in series has gone dark. Across one of the lamps you measure the full supply voltage; across each of the others, 0 V. What has happened?
- The lamp with the full voltage across it has gone open
- The lamp with the full voltage across it is shorted
- The three lamps reading 0 V are all shorted
What you've found:
- An open circuit stops the current. In a series loop, the whole supply voltage appears across the break.
- A short circuit has no voltage across it, and the current goes up, because there's less resistance left in the loop.
- Compare each reading with what it should be. The part whose voltage is wrong in the telling way is the faulty one.
One short deserves special respect: a short straight across the supply. Then there is nothing left in the loop to limit the current. A battery gets hot, a bench supply shuts down, and mains wiring blows its fuse, which is the job fuses are for.
On a real bench most "open circuits" aren't broken parts. They're a leg that isn't pushed fully into the board, a wire in the wrong row, or a broken wire inside its insulation. Most shorts are two bare legs touching. The method is the same: measure, compare with what you expect, and close in.