Spot the topology

Quiz · 8 min

Everything in this module depends on seeing whether two parts are in series, in parallel, or neither. It's easy when the drawing is tidy and surprisingly easy to get wrong when it isn't. Don't go by how it looks. Use two tests.

The test
SeriesMust all the current through one go through the other? (They are joined at a point where nothing else connects.)
ParallelAre both ends of one joined to both ends of the other, by plain wire?

If neither test passes, the answer is neither, and that is common: in most circuits, most pairs of parts are neither.

Ten cases follow: six on paper, then four on a breadboard.

1 of 10. How are the two coloured resistors connected to each other?

  • In series
  • In parallel
  • Neither

2 of 10. How are the two coloured resistors connected to each other?

  • In series
  • In parallel
  • Neither

3 of 10. How are the two coloured resistors connected to each other?

  • In series
  • In parallel
  • Neither

4 of 10. How are the two coloured resistors connected to each other?

  • In series
  • In parallel
  • Neither

5 of 10. How are the two coloured resistors connected to each other?

  • In series
  • In parallel
  • Neither

6 of 10. How are the two coloured resistors connected to each other?

  • In series
  • In parallel
  • Neither

On a breadboard the same questions are harder, because the connections are hidden inside the board. Remember how it's wired underneath:

  • each column of five holes is one strip of metal, so everything plugged into a column is joined;
  • the columns above the middle groove are separate from those below it;
  • each rail is one strip from end to end.

The strips are showing on this board. The last four cases are real boards, without that help.

7 of 10. How are the two resistors on this board connected to each other?

Turn and zoom the board to follow where each leg and wire goes.

  • In series
  • In parallel
  • Neither

8 of 10. How are the two resistors on this board connected to each other?

Turn and zoom the board to follow where each leg and wire goes.

  • In series
  • In parallel
  • Neither

9 of 10. How are the two resistors on this board connected to each other?

Turn and zoom the board to follow where each leg and wire goes.

  • In series
  • In parallel
  • Neither

10 of 10. How are the two resistors on this board connected to each other?

Turn and zoom the board to follow where each leg and wire goes.

  • In series
  • In parallel
  • Neither

The two tests again, because they're worth keeping:

  • Series: the same current, with nothing branching off in between.
  • Parallel: the same two points, so the same voltage.
  • Position on the page or on the board proves nothing. Follow the connections.

On a real bench it helps to redraw. When a board or a diagram won't make sense, sketch it again with the + supply along the top, ground along the bottom and the parts in between. Series and parallel groups usually jump out.