The current divider

Calculate · 10 min

Resistors in series share a voltage, and the bigger resistor takes the bigger share. That was the voltage divider.

Resistors in parallel share a current. A current I arrives at the junction and has two ways to go. Both branches have the same voltage across them, so by Ohm's law the branch with less resistance carries more of the current.

Put numbers on it. The pair together is R1∥R2, so the voltage across them is V=I×R1R2R1+R2. The current in the first branch is that voltage over R1:

I1=I×R2R1+R2I2=I×R1R1+R2

Notice which resistor is on top: each branch's share is set by the other branch's resistor.

Worked example. 30 mA arrives at 1 kΩ in parallel with 2 kΩ:

I1=30×21+2=20 mAI2=30×11+2=10 mA

The 1 kΩ branch, with half the resistance, carries twice the current. And the two add back up to 30 mA, as Kirchhoff's current law says they must.

In a current divider, the branch with the larger resistance carries:

  • The smaller share of the current
  • The larger share of the current
  • Half of it, whatever the values

Problem 1. A current of 36 mA arrives at this pair. How much flows through R1?

Answer in mA.

Problem 2. A current of 20 mA arrives at this pair. This time, how much flows through R2?

Answer in mA.

Problem 3. A meter can only stand a small current, so a low-value resistor is put in parallel with it to carry most of the current round it.

Here R1 is the meter, 9 Ω, and R2 is the bypass, 1 Ω. A current of 200 mA arrives. How much goes through the meter, R1?

Answer in mA.

Problem 4. Three branches. The two-resistor formula no longer fits, but the idea does: each branch's share is its 1/R out of the total of all the 1/Rs.

I1=I×1/R11/R1+1/R2+1/R3

Or in two steps: find the voltage across the group, V=I×(R1∥R2∥R3), then I1=V/R1.

A current of 28 mA arrives at these three. How much flows through R1?

Answer in mA.

Problem 5. Now the current isn't given: work it out first. A 9 V battery feeds R1, and then the current splits between R2 and R3.

How much current flows through R3?

Answer in mA.

Now check one for real. On the board, a 9 V battery feeds a 1 kΩ resistor, and then the current splits between a 1 kΩ branch and a 2.2 kΩ branch.

Before running it: how much current will flow through the 2.2 kΩ branch?

Answer in mA.

Press Run, then Record a reading to note the current into the pair and the current in each branch.

The current divider:

  • a current arriving at parallel branches splits, more of it through the smaller resistance;
  • for two branches, I1=I×R2R1+R2: the other resistor on top;
  • for more, each branch's share is its 1/R out of the sum of them all;
  • the branch currents always add back up to the current that arrived.
Voltage dividerCurrent divider
Parts are inseriesparallel
They sharethe voltagethe current
Bigger share goes tothe bigger resistorthe smaller resistor