The LED needs a resistor

Predict · 7 min

Every LED circuit you've built so far has had a resistor in it. What is it for? One way to find out is to leave it out.

On the board, a red LED is wired straight across a 9 V battery, the right way round, with nothing else in the loop.

Before you run it: what will happen?

  • It lights normally. The resistor only made it dimmer
  • It lights far too brightly for a moment, then burns out
  • Nothing: without a resistor no current flows

Press Run and watch the LED.

Why an LED can't look after itself

A resistor obeys Ohm's law: double the voltage, double the current. An LED doesn't behave like that at all.

  • Below about 1.8 V, a red LED passes almost no current.
  • A little above that, it conducts, and from then on a tiny rise in voltage gives a huge rise in current.

So a conducting LED always has about the same voltage across it, called its forward voltage: about 2 V for red. It will not take more. Connect it to 9 V and the other 7 V has to go somewhere.

With only wire in the loop there is nowhere for it to go, and the current climbs until something gives.

If a red LED takes about 2 V, and the battery is 9 V, how much voltage must the resistor take up?

Answer in V.

Put it right. Add a resistor between the red + rail and the LED's long leg, so the current has to go through both.

You'll need to move the red wire to make room.

What you've found:

  • An LED takes its forward voltage (about 2 V for red) and no more.
  • It does not limit its own current. Something else in the loop must.
  • A series resistor takes up the rest of the supply voltage, and that sets the current.

Going deeper

Would the LED survive on a 2 V supply with no resistor? Only just, and only by luck. The current would swing wildly with the smallest change in the supply, the temperature, or from one LED to the next. Setting the voltage of an LED doesn't work. You set its current, and the resistor is the simplest way to do that.

On a real bench a burnt-out LED often looks perfectly fine. Sometimes it goes dark for good; sometimes it glows dimly ever after. If one behaves oddly after a mishap, swap it for a new one before you go hunting for another fault.

Next: how to choose that resistor's value.