Resistor colour codes

Quiz · 9 min

A resistor is too small to print numbers on legibly, so its value is painted on as coloured bands that can be read from any side.

Each colour stands for a digit:

ColourDigitColourDigit
Black0Green5
Brown1Blue6
Red2Violet7
Orange3Grey8
Yellow4White9

From red to violet they run in rainbow order, which helps.

Reading four bands

Most resistors have four bands:

  1. First digit
  2. Second digit
  3. Multiplier: how many zeros to add
  4. Tolerance: how close the real part is to its marked value. Gold is ±5%, silver ±10%.

The tolerance band sits a little apart from the others. Hold the resistor with it on the right and read from the left.

Worked example. Yellow, violet, red, gold:

  • yellow, violet: 4, 7
  • red: add 2 zeros, giving 4700
  • gold: ±5%

So it's 4.7 kΩ, give or take 5%.

For values under 10 Ω the multiplier band is gold (÷ 10) or silver (÷ 100): yellow, violet, gold is 4.7 Ω.

Your turn. Read three resistors.

Five bands

More exact resistors (±1%, marked with a brown tolerance band) need a third digit, so they have five bands: three digits, multiplier, tolerance.

Brown, black, black, red, brown is 1, 0, 0, then two zeros: 10,000 Ω, or 10 kΩ ±1%.

Read three of these.

Why 4.7 kΩ and not 5 kΩ?

You can't buy every value. With ±5% parts there would be no point: a "5 kΩ" resistor could be anything from 4.75 to 5.25 kΩ, overlapping its neighbours.

So resistors are made in preferred values, spaced so that each one's tolerance range just meets the next. For 5% parts that takes 24 values per decade; the twelve most common are the E12 series:

101215182227333947566882

and the same again times 10, 100, 1000 and so on: 470 Ω, 4.7 kΩ, 47 kΩ.

A calculation says you need 500 Ω to limit an LED's current. Which E12 value would you fit so the current stays under the limit?

  • 390 Ω
  • 470 Ω
  • 560 Ω
  • 500 Ω

Now the other way: given a value, colour the bands. Tap a band, then its colour.

You can now read any resistor in the simulator, or in a parts drawer.

  • Four bands: digit, digit, multiplier, tolerance.
  • Five bands: digit, digit, digit, multiplier, tolerance.
  • Values come from the preferred series; pick the nearest on the safe side.

On a real bench the colours can be hard to tell apart: red, orange and brown look alike under poor light, and on blue-bodied 1% resistors even more so. Nobody will think less of you for checking with a multimeter set to ohms. Tiny surface-mount resistors skip colours altogether and print the same code as digits: 472 is 4, 7 and two zeros, 4.7 kΩ.