The Wheatstone bridge

Build · 12 min

A Wheatstone bridge is two voltage dividers side by side across one battery, with a voltmeter between their midpoints. The meter reads the difference between the two dividers' outputs.

When the two dividers split the supply in the same ratio, their midpoints sit at the same voltage, the meter reads zero, and the bridge is balanced:

R1R2=R3R4

The left arm is built: 10 kΩ over 22 kΩ. Build the right arm from two resistors in the drawer so the bridge balances. Join its top to the + rail and its bottom to the − rail with wires, then put the meter between the two midpoints. Press Run.

Real resistors are never exactly their marked value, so a bridge usually has a trimmer: a pot that lets you nudge one arm into balance.

This right arm is 2.7 kΩ, then a 500 Ω pot, then 5.6 kΩ, with the pot's wiper as the arm's midpoint. The meter is across the bridge. Press Run, click the pot, and turn its dial until the meter reads within 5 mV of zero.

Here is why bridges are used. Suppose the left arm's 22 kΩ is a sensor, and it rises by just 1%, to 22.22 kΩ.

A voltmeter on the left midpoint alone would see 6.19 V become 6.21 V, a change easy to miss in a reading that big. Across the balanced bridge, the meter starts from zero.

What would the bridge's meter read now? Give its size.

Answer in mV.

The bridge is balanced again, and its battery runs down from 9 V to 8 V. What happens to the meter's reading?

  • It stays at zero: both midpoints fall by the same fraction
  • It reads about −1 V
  • It reads about 1 V

The Wheatstone bridge:

  • two dividers across one supply, with a meter between their midpoints;
  • balanced, reading zero, when R1/R2=R3/R4: only the ratios matter;
  • a small change in one arm gives a small voltage from zero, easy to see and amplify;
  • at balance the reading doesn't depend on the supply voltage.