The classic breadboard mistakes

Debug · 8 min

Here are three boards. Each should light its LED, and none does: each has one of the classic breadboard mistakes.

On each, work out what's wrong, then fix it.

Board 1. Look closely: zoom in if it helps. What's wrong?

  • An LED with both legs in the same column
  • Rails that aren't connected to the battery
  • A leg in a column with nothing else in it
  • An LED in backwards

Fix it: move the LED so its long leg shares the resistor's column, and its short leg the black wire's.

Board 2. This one's built on the far side of the board. What's wrong?

  • An LED with both legs in the same column
  • Rails that aren't connected to the battery
  • A leg in a column with nothing else in it
  • An LED in backwards

Fix it: join the far rails to the near ones. A red wire from + to +, and a black one from − to −.

Board 3. What's wrong here?

  • An LED with both legs in the same column
  • Rails that aren't connected to the battery
  • A leg in a column with nothing else in it
  • An LED in backwards

Fix it, whichever way you like.

When a circuit won't work, check these first:

  1. Legs in one column. Every leg needs a strip of its own.
  2. Rails not connected. The battery only powers the rails its leads are in.
  3. A leg on its own. Every leg should share its column with something.

And turn the LED round if it's in backwards: long leg towards +.