Placing parts and wires

Build · 7 min

This time you'll place the parts yourself, with no outlines. There's one rule to remember:

Every leg gets a strip of its own.

Two legs in the same column are joined by the clip underneath, so the current skips the part.

Plug in a resistor, with its two legs in two different columns.

Join one leg of the resistor to the red + rail with a wire.

Then make that wire red: click it, and pick red in its panel. Red for +, black for −. The colour changes nothing electrically, but the habit saves a lot of mistakes.

Add an LED: its long leg in the column of the resistor's free leg, and its short leg in a column of its own.

Now a push button. Its four legs are too far apart for one side of the board, so it sits across the gap in the middle, two legs each side.

Put it so one pair of its legs shares a column with the LED's short leg.

Finish the loop with a black wire from the button's other side to the black − rail.

Press Run. Then press and hold the button: click it and keep the mouse button down, or hold a finger on it.

Three parts, and every leg in a strip of its own.

On a real bench: breadboard clips are stiff. Push legs straight down, and trim long legs so bare metal can't touch the leg beside it. Push buttons often need a firm press to sit properly across the gap.