How a breadboard is connected inside

Explore · 6 min

A breadboard looks like a grid of separate holes, but it isn't. Under the plastic, metal clips join the holes in groups.

This is the board with its insides showing. Each silver bar is one clip: a strip.

Without the X-ray now. Click every hole that's joined to the marked one. Clicking a hole again takes it back.

Right: a column of five, A to E, under one number. A part's leg in any of them is joined to anything else in them.

Now this hole, across the gap down the middle. Click every hole joined to it.

Each column is really two strips, one each side of the gap. The gap is there so a chip can sit across it with every pin in a strip of its own.

The long strips along the edges are the power rails. Click five holes joined to this one.

Each rail runs the whole length of the board. The battery's leads go into the near pair, so the whole red rail is + and the whole black rail is −.

The far pair of rails is separate: it's joined to nothing until you wire it to the near pair.

On a real bench: on some longer breadboards each rail is split halfway along. A break in the red or black line marks it. Join the two halves with a short wire.

Which two holes are joined?

  • A3 and E3
  • E3 and F3
  • A3 and A4

Someone plugs a resistor in with one leg in B7 and the other in D7. What happens?

  • The current goes through the resistor
  • The current goes around the resistor, through the strip