Loading a divider

Predict · 10 min

A divider is only useful if its output goes somewhere. Whatever it feeds, a lamp, a chip, another circuit, is its load: something that draws current from the output.

On the board is a divider made of two 10 kΩ resistors across 9 V, with a voltmeter on its output. Press Run. What does the output read with nothing connected to it?

Answer in V.

Now suppose a 10 kΩ load is connected from the output to ground: the same resistance as each of the divider's own resistors.

What will the output do?

  • Stay at 4.5 V: the divider sets the voltage, and the load just uses it
  • Drop a little, to about 4.3 V
  • Drop a lot, to 3 V
  • Drop to 0 V

Try it. Add a 10 kΩ resistor from the output column to the − rail, beside the bottom resistor, and watch the meter.

Why it sags

The load sits across the same two points as the bottom resistor: the output and ground. So the two are in parallel, and together they are a smaller resistance than R2 alone:

R2∥RL=R2×RLR2+RL=10×1010+10=5 kΩ

The divider is now really 10 kΩ over 5 kΩ:

Vout=9×510+5=3 V

That is the whole method. Replace R2 with R2 in parallel with the load, then use the divider formula as before.

Looked at another way: the load's current has to come through R1, on top of the current R2 was already taking. More current through R1 means a bigger drop across it, and less left at the output.

A load can only ever make the bottom of the divider:

  • Smaller, so the output falls
  • Bigger, so the output rises
  • Either, depending on the load

A divider across 9 V has R1 = 1 kΩ and R2 = 2.2 kΩ. A load of 10 kΩ is connected to its output.

What is the output voltage with the load connected?

Answer in V.

Back to the board: 10 kΩ over 10 kΩ, across 9 V. Before you touch it, work out what the output will be if the load is changed to 1 kΩ, a much heavier load that draws more current.

Answer in V.

Check it: click the load resistor (the one lying beside the bottom resistor) and change it to 1 kΩ.

Now the other way. Change the load to 1 MΩ, a hundred times bigger than the divider's resistors, and read the meter.

A divider made from 10 kΩ resistors has to feed one of these loads without its output moving much. Which is the easiest for it?

  • A 470 Ω load
  • A 10 kΩ load
  • A 2.2 MΩ load

Loading a divider:

  • a load connected to the output is in parallel with R2;
  • so the output falls: work it out by replacing R2 with R2∥RL;
  • a load much bigger than the divider's resistors hardly moves it; a load as small as them, or smaller, wrecks it.

On a real bench this is the commonest reason a divider that worked on paper reads low in the circuit. If a divider's output is lower than you calculated, ask what is connected to it.