The potentiometer

Lab · 10 min

A voltage divider gives a fixed fraction of its supply. To change the fraction you'd have to swap a resistor. A potentiometer, or pot, lets you change it by turning a knob.

Inside is one long resistor, the track, with a terminal at each end. A third terminal, the wiper, is a contact that slides along the track as the knob turns. Wherever it stops, it splits the track into two resistors: one above it and one below.

TerminalWhat it is
1 and 2the two ends of the track
W (the middle leg)the wiper

Drag a potentiometer onto the board, with each of its three legs in a column of its own. Then wire one end leg to the − rail and the other end leg to the + rail. Leave the middle leg free.

The whole 10 kΩ track is now across the battery, and the wiper taps off part of the way along it.

Open the multimeter and measure the wiper's voltage: red probe in the middle leg's column, black on the − rail.

Now turn it. Click the potentiometer and drag its dial, watching the meter.

Set the wiper to 3 V, give or take 0.2 V.

A 10 kΩ pot is wired across 5 V, and its wiper is a 40% of the way up the track from the grounded end.

What is the wiper's voltage?

Answer in V.

Two terminals: a variable resistor

Used with all three terminals, a pot is a variable divider. Used with only two, the wiper and one end, it is simply a resistor whose value you can turn: from almost nothing up to the pot's full 10 kΩ.

This board has an LED and its 470 Ω resistor, with a gap where the circuit should carry on to the − rail. Fill the gap with a pot wired as a variable resistor: the LED's free leg to one end of the pot, and the pot's wiper to the − rail. Leave the other end unconnected.

Turn the dial and watch the LED. Then leave it set so that the LED is dim: lit, but with less than 2 mA.

A volume knob has to pass on an adjustable fraction of a signal's voltage to the amplifier after it. How should its pot be wired?

  • With all three terminals, as a divider
  • With two terminals, as a variable resistor
  • Either: they do the same thing

The potentiometer:

  • one resistor track with a sliding wiper;
  • three terminals: a divider whose fraction follows the knob, from 0 to the full supply;
  • two terminals (wiper and one end): a variable resistor, from about 0 Ω to the pot's full value. Always leave a fixed resistor in series if 0 Ω would be dangerous.

On a real bench the unused end of a two-terminal pot is usually wired to the wiper. It changes nothing while all is well, but if the wiper ever lifts off a worn track the circuit sees the pot's full resistance instead of an open circuit.