Measuring resistance and continuity

Lab · 10 min

This block is a resistor pack: three resistors with no markings. Each runs straight across, from a pin on one side of the centre gap to the pin facing it: A in column 10, B in column 11, C in column 12.

Open the multimeter (the button at the bottom left of the board) and pick Ohms. There's no battery: on ohms, the meter supplies its own small test current.

Put the probes across resistor A: one probe in column 10 on this side of the gap, the other in column 10 on the far side. Press Run. What is A?

Answer in Ω.

Now resistor B, in column 11. What is it?

Answer in Ω.

And resistor C, in column 12?

Answer in Ω.

Here an ohmmeter is across one resistor of a divider that's connected to its battery. Press Run and open the multimeter. What does it show, and why?

  • No reading: the battery's current through the resistor would swamp the meter's own small test current
  • The resistor's value, as usual
  • Zero: the battery shorts it

No battery this time. The ohmmeter is across a 1 kΩ resistor, but a 2.2 kΩ resistor shares the same two strips. Press Run and read the meter. What does it show?

Answer in Ω.

Below 30 Ω, the meter also marks two points as joined: that's a continuity test, for checking wires and connections.

One of these two long jumper wires is broken inside. The probes are on the ends of the red one. Press Run, then check the yellow one too. Which wire is broken?

  • The red one
  • The yellow one
  • Neither

Measuring resistance:

  • the meter on ohms supplies its own small test current, so the circuit must be unpowered;
  • it measures every path between its probes: lift a leg to measure one part on its own;
  • below 30 Ω it marks continuity, the quick test for a broken wire or a bad joint.