Tolerance

Explore · 10 min

Every resistor is made to a tolerance: how far its real value may be from the marked one. Its last colour band says which: gold is ±5%, brown is ±1%.

These two are both marked 10 kΩ, ±5%. So each is somewhere from 9.5 kΩ to 10.5 kΩ.

An ohmmeter is across the left one. Press Run and open the multimeter. What does it really measure?

Answer in Ω.

Here are the same two as a divider across 9 V: the 10.4 kΩ on top, the 9.7 kΩ underneath. On paper, two 10 kΩ resistors give 4.5 V.

Press Run. What does the midpoint really read?

Answer in V.

How far off could a divider like this be? Build a hundred of them, from resistors anywhere within their tolerance, and see where their outputs land. Then do the same with ±1% resistors.

The worst case is each resistor at the end of its tolerance that hurts most. For the highest output, the top resistor is as small as it can be and the bottom one as big:

Vmax=9 V×10.5 kΩ9.5 kΩ+10.5 kΩ

What is the highest output two ±5% 10 kΩ resistors can give?

Answer in V.

A divider of 2.2 kΩ over 6.8 kΩ across 9 V, both resistors ±5%. What is the lowest its output can be?

Answer in V.

A ±1% resistor costs a little more than a ±5% one. When is it worth it?

  • When the circuit's job depends on an exact value: a reference voltage, a measurement, a filter's frequency
  • Always: more accurate is always better
  • Never: 5% is close enough for anything

Tolerance:

  • every part is only within its tolerance of the marked value: gold band ±5%, brown ±1%;
  • a divider's output then lands in a range; the worst case puts each part at its most damaging end;
  • for the highest output: top resistor low, bottom high; for the lowest, the reverse;
  • pay for 1% parts where a value sets an accuracy.