Thévenin by calculation

Calculate · 11 min

Last lesson you found a sealed box's Thévenin equivalent by measuring it. When you can see the circuit, you can calculate it instead:

  1. Vth: the voltage at the terminals with nothing connected to them. Use whatever works: a divider, nodal analysis, superposition.
  2. Rth: turn every battery off (replace it with a wire), then find the resistance between the terminals. With the batteries gone, it's a plain resistor network: reduce it with series and parallel.

Worked example: the box. With the output open, no current flows in the 470 Ω, so Vth is the 1 kΩ / 2.2 kΩ divider's output: 9 × 2.2 ÷ 3.2 = 6.19 V.

For Rth, replace the battery with a wire. Looking in from the terminals: the 470 Ω, then the 1 kΩ and 2.2 kΩ, which now both go from the middle point to the bottom, so they're in parallel:

Rth=470+1000×22001000+2200=470+687.5=1157.5 Ω

Why does the battery become a wire when you turn it off, and not a gap?

  • A battery set to 0 V still conducts: it holds 0 V across itself whatever the current, which is what a wire does
  • Because batteries have no resistance
  • It doesn't matter which

Network 1. What is Vth between A and B?

Answer in V.

Network 1, continued. And its Rth?

Answer in Ω.

Network 2. Two batteries. Treat R2 as the load: take it out, and find the Thévenin equivalent of everything else, seen from where R2's two ends were. Then put R2 back and find the current through it.

What current flows through R2?

Answer in mA.

Network 3. This is where Thévenin pays off. A load will be connected between A and ground, and you need its current for several different loads. Rather than solving the whole ladder each time, reduce it once.

Find the ladder's Vth and Rth at A, then: what current flows in a 1 kΩ load?

Answer in mA.

Thévenin equivalents can be applied in steps, as in the last problem: a source and two resistors replaced by one source and one resistor, which then becomes part of the next stage. Why does that work?

  • The equivalent behaves exactly like the original at its terminals, so the rest of the circuit can't tell the difference
  • It's an approximation that's usually close enough
  • It only works for ladders

Thévenin by calculation:

  1. Vth: the open-circuit voltage at the terminals, by any method;
  2. Rth: turn every voltage source into a wire (and every current source into a gap), then reduce the resistors seen from the terminals;
  3. reuse it: once a network is reduced, every load is one Ohm's law calculation.

The Norton equivalent, next, is the same idea with a current source.