Ohm's law

Lab · 10 min

A bigger voltage pushes harder, so you'd expect more current. But how much more? Twice the voltage, twice the current? Or something less tidy?

Georg Ohm settled it in 1827 by measuring, and you're about to repeat his experiment.

On the board is one resistor across a battery that starts at 3 V. Press Run.

Now take readings. Press Record a reading below to note the voltage across the resistor and the current through it.

Then change the battery's voltage and record again. Do this for at least five different voltages between 1.5 V and 12 V, and watch the graph.

What does a straight line through zero tell you about the current and the voltage?

  • The current is the same whatever the voltage
  • The current is proportional to the voltage: their ratio never changes
  • The current rises faster and faster as the voltage goes up

Pick any one of your readings and divide its voltage by its current (in amps, not milliamps). What do you get?

Answer in Ω.

Ohm's law

V=I×R
SymbolMeaningUnit
Vvoltage across the resistorvolts (V)
Icurrent through itamps (A)
Rits resistanceohms (Ω)

It can be turned round to find whichever one you don't know:

I=VRR=VI

Worked example. 9 V across 680 Ω:

I=9 V680 Ω=0.0132 A=13.2 mA

On your graph, the line's steepness is I/V, which is 1/R. So a bigger resistance means a flatter line.

What if the resistor were 2.2 kΩ instead of 680 Ω, a bit more than three times as big? Where would its line go on the graph?

  • Above the first one: steeper
  • Below the first one: flatter
  • On top of the first one

Find out. Click the resistor and change its value to 2.2 kΩ. Then record readings at three or more different battery voltages.

What you've found:

  • For a resistor, current is proportional to voltage.
  • The ratio V/I is its resistance, in ohms.
  • V=I×R gives any one of the three from the other two.

Going deeper

Ohm's law isn't a law of nature like the conservation of charge. It is a description of how some things behave: metals and resistors, at a steady temperature. Plenty of parts don't follow it, among them LEDs, as you'll see at the end of this module. A part that does is called ohmic.

On a real bench you'd do this with a variable bench power supply and two multimeters, one for volts and one for milliamps. Real resistors also warm up as the current rises, which shifts their resistance very slightly, and each is only within a few per cent of its marked value.