Resistance

Explore · 8 min

In Lab Orientation, a resistor stopped your LED from getting too much current. How does a part hold current back?

The free electrons drifting through a metal don't get a clear run. They keep bumping into the metal's atoms, losing the speed they'd picked up and handing their energy over as heat. The more of this a path does, the less current a given voltage can push through it.

That opposition is resistance, measured in ohms (Ω). Everything has some: a short copper wire a tiny fraction of an ohm, your skin hundreds of thousands, air almost endlessly much.

Three things set the resistance of a piece of wire: what it's made of, how long it is, and how thick it is.

Before you try it: a wire is swapped for one twice as long, the same in every other way. What happens to its resistance?

  • It halves
  • It stays the same
  • It doubles
  • It goes up four times

And if the wire is made twice as thick (twice the cross-section area), at the same length?

  • Its resistance halves
  • Its resistance stays the same
  • Its resistance doubles
  • Its resistance goes up four times

Now test both predictions. The dots show the current a 1.5 V cell would drive through the wire.

The maths

R=ρLA
SymbolMeaningUnit
Rresistanceohms (Ω)
ρresistivity of the materialohm metres (Ω·m)
Llengthmetres (m)
Across-section areasquare metres (m²)

Worked example. 2 m of nichrome wire (ρ=1.1×10−6 Ω·m) with a cross-section of 1 mm², which is 1×10−6 m²:

R=1.1×10−6×21×10−6=2.2 Ω

The same wire in copper (ρ=1.7×10−8 Ω·m) would be only 0.034 Ω.

A 4 m length of heating wire has a resistance of 12 Ω. What is the resistance of 8 m of the same wire?

Answer in Ω.

A cable has a resistance of 24 Ω. It is replaced by one of the same length and metal, but with 2 times the cross-section area. What is the new cable's resistance?

Answer in Ω.

Going deeper

MaterialResistivity (Ω·m)Used for
Silver1.6×10−8the best conductor, but costly
Copper1.7×10−8wires, circuit boards
Aluminium2.7×10−8power lines
Nichrome1.1×10−6heating elements
Carbonabout 3×10−5resistors
Glassmore than 1010insulation
  • A resistor is a deliberately bad conductor. A thin film of carbon or metal is laid on a ceramic rod and cut into a spiral, making a long, thin path in a small space. Changing the film and the cut gives any value from under an ohm to millions.
  • Temperature matters. Most metals resist more as they heat up, because their atoms jostle harder and get in the way more. A lamp filament has about ten times the resistance hot that it has cold.

On a real bench a jumper wire is a few hundredths of an ohm, far too little to matter beside the hundreds or thousands of ohms in your circuit. That's why lessons treat wires, and breadboard strips, as having no resistance at all.