Series-parallel reduction

Calculate · 10 min

Most real circuits are neither purely series nor purely parallel. They're a mixture. But a mixture can usually be worked out with only the two rules you know, by collapsing it one group at a time, from the inside out.

Here's a network of four resistors between two points, A and B. Step through it.

The method

  1. Find a group of resistors that is purely series (end to end, nothing else joined in between) or purely parallel (both ends in common).
  2. Replace the group with one resistor: add for series, product over sum for parallel.
  3. Redraw, and go back to step 1 until one resistor is left.
GroupCombined value
SeriesRa+Rb
ParallelRa×RbRa+Rb

A useful check at every step: a series group comes to more than its biggest resistor, a parallel group to less than its smallest.

Which pair should be combined first in the network you just saw, and why?

  • R1 and R2: they come first, reading from the left
  • R3 and R4: they are purely in series, with nothing joined between them
  • R2 and R3: they are next to each other

Network 1. What is the resistance between A and B?

Answer in Ω.

Network 2. The same three kinds of joint, arranged the other way. What is the resistance between A and B?

Answer in Ω.

Network 3. Three branches this time. What is the resistance between A and B?

Answer in Ω.

Network 4. A ladder: work from the far end back towards A. What is the resistance between A and B?

Answer in Ω.

Network 5. A longer ladder, across a 9 V battery. Work out the resistance the battery sees, and from it: what current does the battery supply?

Answer in mA.

That is series-parallel reduction: find a pure group, replace it, redraw, repeat.

  • Redraw after every step. Most mistakes come from trying to hold a half-reduced network in your head.
  • Check each step's size: series comes to more than the biggest, parallel to less than the smallest.
  • Once the whole network is one resistor, Ohm's law gives the supply's current. Working back out through the steps then gives every voltage and current inside.

Going deeper

Not every network gives in to this method. In a bridge, five resistors are joined so that no two of them are purely in series or purely in parallel, and there is no group to start with. Those need Kirchhoff's laws written out as equations, or the tricks of the next module.

On a real bench you can check any of these in seconds: build the network, leave the battery off, and measure across it with a meter set to ohms.