Superposition

Lab · 11 min

The two-battery circuit again: 9 V on the left, 6 V on the right, and the node between R1, R2 and R3. A meter is already on the node.

Press Run, and read the multimeter: its red probe is on the node, its black on the − rail.

What is the node voltage with both batteries in?

Answer in V.

Superposition

Here's a different way to get that number. In a circuit made of resistors and sources, every voltage and current is the sum of what each source would cause on its own.

So: find the node voltage with only the 9 V battery working, then with only the 6 V battery working, and add the two.

What does "only one working" mean for the other battery? Not taking it out and leaving a gap: the point is to keep the circuit's resistances as they were, and remove only the battery's push. A battery with its push removed is a 0 V source, and a 0 V source is a plain wire.

To turn a battery off for superposition, you:

  • Replace it with a wire
  • Take it out and leave its leads' holes empty
  • Turn it round

On this copy of the board, turn the 6 V battery off: delete it, and put a wire where it was, from its + hole (column 18) to the − rail.

Then read the node voltage.

Answer in V.

And now the other way round. On this board the 9 V battery has been turned off for you: it's gone, and a wire joins the + rail to the − rail where it was. The 6 V battery is back.

Press Run, and read the multimeter: its red probe is on the node, its black on the − rail.

What is the node voltage with only the 6 V battery working?

Answer in V.

Add your two readings: the node with only the 9 V battery, plus the node with only the 6 V battery. What do they come to?

Answer in V.

Superposition works for voltages and currents. Does it work for power? With only the 9 V battery, R2 dissipates 6.1 mW; with only the 6 V battery, 2.7 mW. With both in, does R2 dissipate their sum, 8.8 mW?

  • No: power goes as voltage squared, and the square of a sum isn't the sum of the squares
  • Yes: everything adds

Superposition:

  • in a linear circuit (resistors and sources), every voltage and current is the sum of each source's effect on its own;
  • to turn a voltage source off, replace it with a wire;
  • find each source's contribution, then add them, with their signs;
  • it works for voltages and currents, not for power.

On a real bench this is how engineers think about a signal riding on a DC level: the DC supply sets one part of a voltage, the signal adds the other, and each can be worked out on its own.