Thévenin equivalent by measurement

Lab · 12 min

This black box has a network of resistors sealed inside, powered from the 9 V battery through its IN pins. You can't see in. All you can reach is its two OUT pins.

Thévenin's theorem says that however complicated the inside is, as long as it's made of resistors and sources, from its two output terminals it behaves exactly like a single battery Vth in series with a single resistor Rth. Two numbers describe the whole box, and two measurements find them.

The first: measure the output with nothing connected to it. With no current flowing, nothing drops across Rth, so the meter reads Vth itself.

Open the multimeter (the button at the bottom left of the board), leave it on Volts, and put red on OUT+ (column 10, on the far side of the centre gap) and black on OUT− (column 13, on the far side). Then press Run. What is Vth?

Answer in V.

The second measurement: connect a known load and see how far the output falls. Put a 1 kΩ resistor across the output: from H10 to H13, say. Leave the meter where it is.

What does the output read now?

Answer in V.

Working out Rth

With the load connected, the box's model is a divider: Vth across Rth and RL in series. The load gets

VL=Vth×RLRth+RL

Rearranged for the one unknown:

Rth=RL×(VthVL−1)

Use your two readings, with RL = 1 kΩ. What is Rth?

Answer in Ω.

Test the model on a load it hasn't seen. If the load is changed to 2.2 kΩ, what will the output be, according to your Vth and Rth?

Answer in V.

Click the load and change it to 2.2 kΩ. Does the meter agree with your prediction?

Here is what's inside the box. Work out its Vth and Rth on paper, to check.

  • Vth: with nothing on the output, no current flows in the 470 Ω, so OUT+ is at the middle point: a 1 kΩ over 2.2 kΩ divider of 9 V.
  • Rth: turn the battery off (replace it with a wire, as in superposition) and find the resistance looking in at the output: 470 Ω in series with (1 kΩ ∥ 2.2 kΩ).

What do you get for Rth?

Answer in Ω.

Thévenin's theorem:

  • any network of resistors and sources, seen from two terminals, is equivalent to one battery Vth in series with one resistor Rth;
  • Vth is the open-circuit voltage at the terminals;
  • Rth follows from a loaded reading: Rth=RL(Vth/VL−1);
  • or, on paper, Rth is the resistance seen at the terminals with every source turned off.

On a real bench this is how you characterise anything with an output: a battery, a sensor, a power supply, an amplifier. Its Rth is called its output resistance, and it tells you how much the output will sag under a load.